Lucipac A3 Surface Sterile dry swabs for fluids and surfaces Kikkoman Hyserve

See instrument PD-30 for using with Sterile dry swabs for surfaces

Lumitester Smart

Preparation for swab test

1. Remove the swabs (green holder) out of the socket.
2. If the surface is completely dry, moisten the swab with water.
3. Swab the item / surface to be investigated. We recommend to swab ca. 10 x 10 cm² area for an optimal evidence.
4. Re-introduce the swab into the socket again.
5. Subsequently press the stick through the first chamber and further down to the bottom in order to destroy the foils of both separated reaction chambers.
6. Horizontally shake the LuciPac A3 several times. See all the fluid being collected in the lower reaction chamber to dissolve the lyophilized reagent.
7. Finally, introduce the complete LuciPac A3 into the measuring chamber of the Lumitester Smart, and close the lid.
8. Press the ENTER button of the operator control field to start the measurement. Results are available after 10 seconds.
9. Remove the socket of the LuciPac A3 out of the Lumitester Smart device.

Key Features:

• Sampling swab with releasing reagent and luminescent reagent
• 100 swabs/kit (20 x 5 aluminum bags)
• Storage between 2 to 8℃ (Do not freeze)
• Expiry 15 months after manufacturing date

Note:

• Lumitester Smart are designed instruments for LuciPac A3.
• It is not to be used for counting general living bacteria or detecting specific pathogens.